CAD axle shaft... ick

[Follow Ups] [Post Followup] [Dodge Power Wagon Forum]

Posted by Alex J [100.4.90.161] on Thursday, January 08, 2015 at 21:24:10 :

In Reply to: looks like old style spline was good nuff for posted by clueless [201.202.24.222] on Thursday, January 08, 2015 at 18:05:01 :

Thats for a CAD system, which was a severely problematic setup.. Also not the shaft diameter decrease that way the spline roots aren't the highest stress riser.

Follow Ups:

look at the pic of the pinion gear - clueless 22:43:42 01/08/2015

Re: CAD axle shaft... ick - clueless 22:06:44 01/08/2015

Center Axle Disconnect - Alex J 22:14:11 01/08/2015
- Re: Center Axle Disconnect - clueless 22:45:28 01/08/2015
  - Re: Center Axle Disconnect - Kaegi 23:30:21 01/08/2015
    - Re: Center Axle Disconnect - clueless 23:33:40 01/08/2015
      - Ramcharger... Wagoneer, even YJ Wrangler - Alex J 06:41:16 01/09/2015
        
        had a 80 something ramcharger - clueless 10:47:08 01/09/2015

Post a Followup

Name:
E-Mail:
Subject:
Message:

Optional Link
URL:
Title:
Optional Image Link
URL:

This board is powered by the Mr. Fong Device from Cyberarmy.com