Posted by clueless [201.237.45.94] on Friday, November 21, 2014 at 15:28:44 :
In Reply to: pwff style splines posted by clueless [201.237.45.94] on Friday, November 21, 2014 at 15:25:06 :
Enter Axle Dimensions
A - Overall END to END shaft length.
B - END of the shaft to the END of the seal surface if applicable. Enter N/A if no seal surface.
C - END of the shaft to the START of the seal surface if applicable. Enter N/A if no seal surface.
D - Length in inches of the spline
E - Length in inches of the spline
F - Length in inches of the spline
G - Length in inches of the snap ring groove
Spline Count
Inner
Outer