Posted by Tweety [205.200.11.36] on Monday, June 30, 2014 at 17:17:20 :
In Reply to: Re: Seems to me that's one thing that needs to be reproduced. nt posted by Sherman in Idaho [72.47.153.28] on Monday, June 30, 2014 at 16:45:21 :
At some point I'm planning on putting a frame on my CMM (coordinate measuring machine) and getting the cross sectional profile.
I'll then draw it up and have my EDM (electrical discharge machining) guy wire out a 12" tall section as that is his max height. Until I know the cut length, I can't estimate the cost, but it will be a LOT.
If a bad straight section can be replaced with a spliced in piece, that is the main goal.
I'm going to only do it for academic reasons and to see if I can get it done.
I'll for sure post up the results when I get that far, most likely towards the end of summer.
Follow Ups: