Posted by Photo Classifieds [68.184.47.175] on Wednesday, May 21, 2014 at 19:42:37 :
1957 K6-W300 Power Wagon.
The truck has had a complete frame off restoration, that was completed in June 2011.
Approximately 300 miles have been put on it since it was completed. The frame was sandblasted and primed and sprayed with DuPont 34P gloss black.
All the leaf springs were taken apart and individually sandblasted, primed, and painted. All new bushings were also installed. All U-joints have been replaced.
Brakes: everything on the brake system is new. Master cylinder, wheel cylinders, shoes,springs, lines; drums were turned.
Bell housing was shot blasted, primed and painted.
Installed new clutch and pressure plate, and clutch fork bushing. The flywheel was resurfaced.
Several parts were replaced on the transmission.
New bearings and seals put in the transfer case.
Gas tank was sent to RENU- USA.
All new exhaust system, new fuel pump, new water pump.
The radiator was recored, heater motor rebuilt, starter rebuilt.
New tie rod ends installed.
Both rear axle shafts are new, all bearings, bushings, seals have been installed on front and rear axles.
Stock 230 cu. engine has been rebuilt (have list of what all was done).
Rear differential was rebuilt, front was not as it was in nice shape.
All the glass is new, and the windshield frame was very solid for those of you who know about these.
New STA superlug 9.00-16 tires along with new flaps and tubes.
The bed wood kit is white ash with stainless hardware from Bruce Horkey.
The 3rd series bed sides are brand new from Matt Tisdale.
Tailgate and front bed panel are new.
Running boards are new.
One of the front fenders was NOS, and the other was quite solid.
Rear fenders were solid take offs from VPW.
Wiring is all new.
The paint is single stage PPG Concept. (Shell Oil green).
I'm sure I have forgotten something!
Last I would like to mention a few things that need to be addressed;
I did put in electric wiper motors, and they still need to be calibrated ( I have instructions).
The hand brake needs some adjusting.
The driver-side vent wing window doesn't seal the way it should.
I have all kinds of pictures of the truck in various stages.
Asking price: $38,000 Thanks, Dave.
I can be reached at (906) 250-3931