Posted by Sherman in Idaho [72.47.153.28] on Friday, May 09, 2014 at 00:05:41 :
In Reply to: Re: Once you install this new one check the exhaust posted by Raef Grohne [24.84.216.255] on Thursday, May 08, 2014 at 15:42:07 :
Unless you're an expert welder, you might try brazing it -- much more forgiving, less likely to crack it further or warp it. Assuming you have a torch, V out the crack so it's clean, get some standard brass brazing rod and flux and give it a try. This assumes you don't care about the looks. I've had good luck brazing quite a few cast iron things, including a manifold.
Follow Ups: