Replace the knuckle cap w/ steel bar stock=

Posted by Chriscase [172.10.15.108] on Wednesday, March 05, 2014 at 13:14:41 :

In Reply to: crossover posted by clueless [201.237.45.94] on Wednesday, March 05, 2014 at 11:27:39 :

Make it long to the front, and ream a tapered hole in it for the tie rod. Also rem tapered holes for the conical sleeves.

I'll bet the right side is cast iron, and the left w/ integral arm, is steel.

Follow Ups:

• Makle two, left and right,right to have holes for TWO tie rod - Chris Case 13:20:34 03/05/2014
  • Re: Makle two, left and right,right to have holes for TWO tie ro - clueless 19:00:40 03/05/2014
  • Re: Makle two: nah, I'm an idjut. - Chris Case 16:21:59 03/05/2014

Post a Followup