Soldering


[Follow Ups] [Post Followup] [Dodge Power Wagon Forum]


Posted by Sherman in Idaho [72.47.153.112] on Thursday, February 20, 2014 at 03:12:16 :

In Reply to: Re: In need of a carb float for a Carter carb posted by GMHarris [69.231.23.51] on Thursday, February 20, 2014 at 00:32:01 :

I have soldered floats up. It's very easy to do. One surprising thing is that the heat of soldering expands the air/fumes inside and keeps blowing the solder out. The solution is to drill a small hole in a convenient place, or leave the last little bit of the crack un-soldered. When most of it is soldered, let it cool down. Then quickly solder up that last little bit or that vent hole before the whole thing has a chance to heat up much. Try not to glop on too much solder or it will affect the weight and the float level adjustment will be off.



Follow Ups:



Post a Followup

Name:
E-Mail:
Subject:
Message:
Optional Link
URL:
Title:
Optional Image Link
URL:


This board is powered by the Mr. Fong Device from Cyberarmy.com