Posted by Vaughn [99.104.67.174] on Sunday, February 09, 2014 at 20:02:27 :
About a month ago, my clutch failed while driving, and since these transmission/PTO units are rather heavy together, I decided to make a saddle or adaptor to use with my transmission jack. Today I put it to use, and removed my transmission/pto unit. It was nice to be able to pull the transmission back from the bell housing and lower it down without the usual straining. The trans/pto unit sets nice and secure on top of the jack. Don't know how it's going to work installing the trans, but it will be a lot easier than what I've done in the past. Hopefully this will give you an idea if you decide to make your own. I hope the link works. The first image is of the failed disk, last image, the saddle.
Follow Ups: