Posted by Fred Darvill on Tuesday, June 19, 2001 at 4:12PM :
In Reply to: Re: Wire Feed Welders - Sears question? posted by RDavis on Sunday, June 17, 2001 at 10:33PM :
Mine is 110 and the cheaper version. I found that seting 2 with a wire speed of 3 to 3 1/2 is good for sheet metal like the cab and setting 3 at a speed of 4 1/2 was good for 3/16 diamond plate. I bought a fairly large cylinder of gas from NAPA versus renting a cylinder. I've run several spools of wire and still haven't run out of gas. When the gas runs out I simply get to trade cylinders for a full one and just pay for the gas the next time.
|
Follow Ups:
This board is powered by the Mr. Fong Device from Cyberarmy.com |