Posted by Sterling [99.98.76.231] on Saturday, January 11, 2014 at 08:32:18 :
As y'all can see the bearing rollers don't seem tall enough. There is a gap between the roller and snap ring. Maybe this is how it should be?
Im going to use a socket to hold the rollers in the upright position. Then cram some grease in there.
Now stabbing the subassemblies into the main case will be one of the last steps. is it best to lye the case on its side and mate them vertically?
or stand the case on it bottom and slide the sub-assembly in from the side?
Thanks for your responses.
Follow Ups: