Re: I'm missing it here - where's the 010 from?

Posted by don in nh [207.121.73.19] on Tuesday, November 26, 2013 at 16:44:16 :

In Reply to: Re: I think I dropped a 0 in there,now you added too many.... posted by Chriscase [108.247.147.80] on Tuesday, November 26, 2013 at 16:00:54 :

Basic understanding question #1: If I have a bearing which is 0.001 undersized for a 2.062 journal, does this mean that the radius of the bearing half is .001 shorter or that the diameter of the bearing pair .001 shorter? I.e in terms of radius a .001 undersized for 2.062 = 2.060ID or for diameter = 2.061?

Basic understanding question #2: probably identical to #1, but if I have a specified "tolerance" or an observed "clearance" is this a radial or a diametral value?

Follow Ups:

• Plastigage measures differences of diameters. - Chriscase 16:58:40 11/26/2013
  • Re: Got it, but what's a factor of 10 amonst friends? - don in nh 17:17:40 11/26/2013
  • Re: Plastigage measures differences of diameters. - Kaegi 17:02:58 11/26/2013
    • No Kaegi, ... - Chriscase 19:26:10 11/26/2013
    • Re: Plastigage measures differences of diameters. - Chewie 18:51:55 11/26/2013
      • Re: Plastigage measures differences of diameters. - Kaegi 02:18:28 11/27/2013
        • Re: Plastigage measures differences of diameters. - Chewie 11:13:09 11/27/2013
          • Re: Plastigage measures differences of diameters. - Kaegi 11:30:25 11/27/2013

Post a Followup