You are stil within spec. Check the rod throws?

Posted by Chriscase [107.201.16.227] on Saturday, November 23, 2013 at 19:50:15 :

In Reply to: Interpreting plasticgauge on main bearing posted by don in nh [96.61.72.163] on Saturday, November 23, 2013 at 18:06:32 :

It's usually # 6 that goes bad first, I guess it runs hotter.

And on mains, it's #1, top, because the belt and chain pull it upwards.

Follow Ups:

• Re: max tolerances - when to shim? - don in nh 07:51:45 11/24/2013
  • 1 1/2 - 3 1/2 was always my rule of thumb. - Chriscase 08:06:07 11/24/2013
    • Re: Thanks. - don in nh 08:32:02 11/24/2013

Post a Followup