Posted by Keith in Washington [24.41.55.59] on Thursday, October 31, 2013 at 13:42:21 :
In Reply to: Re: transfer case shift levers? posted by mannyc [96.224.210.179] on Thursday, October 31, 2013 at 13:10:16 :
Yep it is time to get new bushings in your levers. Any good machine shop can do it. Also replace the shaft that they mount to. It also wears. To replace grind the weld that holds it to the bracket that mounts to the transmission. Then cut a new shaft out of 3/4 round stock and drill the hole for the cotter pin. Weld to the bracket. When you mount the levers use wavy washers to keep tension between them to reduce rattling.
Follow Ups: