Posted by casebro on Tuesday, June 12, 2001 at 9:30PM :
In Reply to: Pilot Bushing removal posted by Tom Markert on Tuesday, June 12, 2001 at 4:59PM :
Or if you have the right size tap, tap the center, keep turning tap, bushing will get screwed out of it's job.
Re: disc alignment, I just feel through gaps in clutch cover to center disc as I tighten bolts. I this doesn't work perfectly(it's usualy better than a wood or plastic tool), just step on the clutch pedal when it gets close. ALSO- ALWAYS put s couple of long studs in the transmission bolt holes to act as guides when re-installing the tranny, then just slide tranny down the studs, wiggle it a little,it'll go in.If not, step on clutch and wiggle some more, maybee turn engine w/ handcrank. Have FUN!
|
This board is powered by the Mr. Fong Device from Cyberarmy.com |