Posted by Jim Pace on Wednesday, June 06, 2001 at 9:45PM :
In Reply to: PTO-WM300 posted by Dan on Wednesday, June 06, 2001 at 8:47PM :
Dan,
Yes, the dual output pto will run the front mounted winch and a rear mounted (also bed mounted)unit as well. Both shafts turn so it is important to have the front winch clutch "disengaged" if running the rear unit. Likewise have the rear unit disengaged when using the front winch.
These shafts and coupling can be fabricated & purchased at most driveline shops without much difficulty. Often square stock is used for the shaft. Have the diameter of the shaft and the needed length, Take the truck if possible,
Hope this helps.
Jim Pace
|
Follow Ups:
This board is powered by the Mr. Fong Device from Cyberarmy.com |