Posted by Jim in Ok on Wednesday, May 09, 2001 at 1:19AM :
In Reply to: Lock out hubs posted by Greg Gideo on Tuesday, May 08, 2001 at 8:59PM :
Is the Dualmatic made by Spicer?The reason I'm asking is that I purchased a set that came off of a B-3PW.After I cleaned them up,I noticed that one had a small crack in the hub.The crack intersected one of the locking pin holes.This hub has the two levers that pull out and rotate 360'then snap back into the hub.Each lever is held in place by a ball detent.I took the hub to a good welder in hopes to weld and repair the crack.He tried to TIG this area but found the metal was some type of bismuth materal.IT just wouldn't take a weld.Just thought I'd throw this in......Jim
|
This board is powered by the Mr. Fong Device from Cyberarmy.com |