Posted by Daryl in Oz [116.240.181.74] on Tuesday, April 23, 2013 at 18:44:46 :
In Reply to: magic hone posted by clueless [201.205.51.47] on Tuesday, April 23, 2013 at 15:53:21 :
Magic hone works fine, just make sure the parts of the bore where the cups run is good without steps - doesn't matter if it's a little out of shape as long as it's smooth. I'll probably get yelled at for this but the pits in the middle bit and at the ends where the pistons go don't matter so much - only where the rubber contacts.
Follow Ups: