In Reply to: Door seam posted by Earl [72.48.99.46] on Sunday, March 17, 2013 at 08:59:59 :
Pic 30 shows the truck before paint on the crew cab imageevent site joe hosts.
When I built that truck it would have been better to use the doors off a early d series without the body line in the doors. The door is aligned the best it can be. Must be a glare during the pic. As you can see when its on my trailer it left my shop unfinished. Its up to the body guy to hammer out and fill to make uniform.
That truck should be worth 16+. There may never be another built. It was a horrible build. The power giant is wider in front than the rear, so the doors had to be shrunk by removing pie shaped slivers. Came out great I think.
Top i'm almost sure I butt welded all seams. Lap welds not good unless special care is taken to seal them up.
Follow Ups: