|
|
Posted by mike stone [71.39.211.42] on Saturday, October 20, 2012 at 12:41:15 :
In Reply to: Lets discuss alignment posted by Tim Holloway [69.54.28.229] on Friday, October 19, 2012 at 18:30:20 :
Ride Height for sure ground to Frame all around.
then mark the centerline of the axles using
a plumb bob - mark the floor
then move the rig & measure front to rear
marks on each side & then the Diagonals
this will tell you if you are working with
1. a rectangle or 2. a parallelogram
if 2 then you have a major problem that needs
to be corrected.
then check the camber with a level if not equal side to side then another problem to be
corrected.
if equal then go on to setting the toe in with whatever winds your clock