Posted by Charlie on Tuesday, April 10, 2001 at 1:52AM :
In Reply to: Re: D44 axle help posted by Garrett on Monday, April 09, 2001 at 2:27AM :
Their new Ford doubler is the "Gen II" design, only 3" thick. It turned out the U-joint on the rear driveshaft went exactly in the same locat1on! I needed a new front shaft, and I had to move my PTO & hydraulic pump to the other side, which in turn led to exhaust modifications. And I needed a 2nd crossmember under the adapter because the 203/adapter/205 weighs over 200 lbs. And new skid plates.
Charlie
This board is powered by the Mr. Fong Device from Cyberarmy.com |