Posted by Steve Kanavas on Sunday, April 08, 2001 at 10:15AM :
In Reply to: DENNMAN NDT posted by JD on Sunday, April 08, 2001 at 7:37AM :
Have a set. Got them from Wallace Wade Co in Texas. Get tubes talc and flaps at the same time. Think they're up to about $115 now.
Appearance fine, tread fine. They were a bit hard to balance. One of them was out quite a lot. Typical bias ply truck tires. They'll flat spot if the truck sits for a couple weeks and you'll bounce down the road for a few miles before they remember that they're supposed to be round. Otherwise they're just NDT's. Stay off snowy roads or you'll swap ends in an eye blink.
sak
|
Follow Ups:
This board is powered by the Mr. Fong Device from Cyberarmy.com |