Posted by PeterS on Friday, April 06, 2001 at 1:42PM :
In Reply to: Replacement Shear Pin posted by Drew Rogers on Friday, April 06, 2001 at 1:15PM :
Use a commonly available Grade 2 bolt. These are weak and soft enough to allow no damage to winch and PTO. They are identified normally by a plain head with no marks, a raised dot in the center of the head or a single radial line from center to one point of the hex head. Avoid grade 5 and 8 bolts, three and six radial lines respectively. They are too strong and hard.
|
This board is powered by the Mr. Fong Device from Cyberarmy.com |