Posted by Rob Steller on Sunday, April 01, 2001 at 0:50AM :
In Reply to: More questions... posted by Brian in Oregon on Saturday, March 31, 2001 at 2:59PM :
The NP201 used a large single direction 10 bolt PTO made by Arrow Gear I think. #FTB-7?? It covered the entire driver's side of the T-case. These are rather rare, though I have 4 of them, 3 came on my W-300's, one from a junkyard off a W-200 . Some had shafts fore and aft, some only forward. These were cable actuated by a T-handle in the dash. I really like this set-up, as you can change the winch speed by selecting a different gear in the transmission, so I use 3rd or 4th to wind up a cable, 1st or 2nd to do the pulling, and reverse to lower things. With a fixed throttle control, you can get any speed you want and not have to race the engine. Also makes transmission swaps easier! Rob
|
This board is powered by the Mr. Fong Device from Cyberarmy.com |