|
|
Posted by johnd [71.246.88.137] on Saturday, September 15, 2012 at 06:10:08 :
In Reply to: Re: Unsticking a stuck motor posted by Sherman in Idaho [72.47.9.37] on Thursday, September 13, 2012 at 22:24:19 :
I once freed up a 318 Chrysler by bolting a four foot piece of angle iron to the flywheel. I was able to move the flwheel only about 1/16" initially, but that grew and grew until I could move the angle iron to another set of flywheel bolts and keep going. It took a few days of messing with it, but eventually the starter could turn it over.
The engine did eventually run, but not for long.
You might get lucky-I say give it a shot!!