|
|
Posted by Bruce in BC [24.207.19.38] on Tuesday, February 14, 2012 at 20:29:44 :
In Reply to: Paul in new york, wheel wells posted by Tim [98.180.38.207] on Tuesday, February 14, 2012 at 16:31:09 :
You can get the fenders made up to just about any radius and have a nice rolled edge that looks stock . Not sure if it is on the carryall thread or not but a bunch of sources were listed here at one time . I considered going for a 4 inch bigger radius on my carryall , same height as stock but wider at the bottom - the radius would match the tires better . Once you have the radius a filler piece could be welded in with some beads rolled or pounded in that would run parallel to the ground . This would create a nice fender well . Most of the tubs you get for race cars are too thin and look wrong .
Bruce
I was welding in the gaps on my carryall inner support structure today . Hope to stop the squeaks .