|
|
Posted by Will (in IL) [98.215.26.138] on Sunday, January 29, 2012 at 15:28:55 :
Well, I discovered the one rear wheel cylinder was leaking pretty good, and a trickle from the other.
They were a pair of wheel cylinders I'd picked up used, but recently re-built, and did not expect this problem.
The pistons are steel not aluminum, the inner seals are good. I assume it's likely that the castings bore is over-sized, or worn?
The front side measure 1.250" while the rear side measures 1.375", which I believe is the correct diameters, but I do see some areas that have some sign of corrosion.
Guess I'll did through my others pistons and find a better set. Any other suggestions or ideas or anything I should look at?
Will
Follow Ups: