|
|
Posted by Photo Classifieds [68.184.45.92] on Friday, December 16, 2011 at 21:52:10 :
1968 Dodge Power Wagon with dump body
VIN # 2461789297
251 cu. In. Flathead 6 cylinder
Original and runs great but could use some TLC.
Starts easily, drives, brakes work and no trouble with the clutch.
NY State did not issue titles for that year, but, have transferable registration.
If the dump is to get constant use, need plug for hydraulic ram
Have new/not installed wood blocks/supports for running boards, new/not installed window crank handle, new/not installed oil filter
Passenger side “wind wing” is Plexiglas…all other glass present
Windows roll up/down
Both fenders have metal patches/rust holes where they meet the running boards. (Should be an easy fix)
Some dings around front grill/radiator support. (Again, should be an easy fix)
Replaced driver's side floor board and master cylinder cover. (Some minor holes where floor panel bolts to transmission tunnel)
Not sure if vacuum/manual assist wipers work
Cleaned out the gas tank, but installed double in-line gas filters to catch any remaining floaters
Original seat has a hole in front left lower valence
One speed (?) heater works great (full blast)
Driver’s side hinged hood needs about 4 rivets
Info from build sheet and Internet sites:
170 hp, 216 ft-lbs. torque
Axle, front capacity 3750 lbs. w/5.83 ratio
Rear axle capacity 6500 lbs. w/5.83 ratio
4 speed synchromesh manual transmission
Drum brakes
10,000 lb winch
11 in. clutch
126 in. wheel base
Built in Warren, Michigan, Build #9298
$6,000 or BRO
Call (315) 342-4018 and leave a message/name/phone number
Or email rphatch@aol.com