Re: Installing 237 in WC-12

[Follow Ups] [Post Followup] [Dodge Power Wagon Forum]

Posted by Dozerman51 [71.139.167.213] on Tuesday, November 15, 2011 at 19:50:36 :

In Reply to: Re: Installing 237 in WC-12 posted by Kaegi [24.16.253.154] on Tuesday, November 15, 2011 at 19:00:37 :

Thanks for the advice. Do you need the Z bend in the steel? I was going to install either some shim stock or washers to take up the space on the original motor mount that is attached to the crossmember. If I do it this way, will it mess up the transmission and motor alignment?

Follow Ups:

Re: Installing 237 in WC-12 - Kaegi 20:09:25 11/15/2011

Re: Installing 237 in WC-12 - Dozerman51 20:19:52 11/15/2011
- Re: Installing 237 in WC-12 - Kaegi 20:56:50 11/15/2011
  - Re: Installing 237 in WC-12 - Dozerman51 22:39:58 11/15/2011
    - Re: Installing 237 in WC-12 - Kaegi 00:49:57 11/16/2011

Post a Followup

Name:
E-Mail:
Subject:
Message:

Optional Link
URL:
Title:
Optional Image Link
URL:

This board is powered by the Mr. Fong Device from Cyberarmy.com