1948 B1PW for sale.


[Follow Ups] [Post Followup] [Dodge Power Wagon Forum]


Posted by Jonas on Sunday, February 18, 2001 at 0:30AM :

I am selling my '48 B1PW.

It is in very complete condition, All the glass is good, and the winch works perfectly. I have less than 100mi on the motor which I had rebuilt last year (I have all the reciepts) It's been bored .030 over on the pistons .020 on the mains and rods and every moving part has been replaced with new in the engine and everything thing has been balanced. New clutch, pressure plate, & TO bearing, and pilot bushing and the flywheel was re-suraced.
New PTO shaft, and universals.
The Axles have been rebuilt and I replaced or repacked all the wheel bearings. New steering knuckle bushings on top and bearings on the bottom. All seals and gasketts have been replaced in the axles with less that 100mi on them. New wheel cylnders all around for the brakes and the master cylinder was bored out and re sleeved with stainless.
The electricial system has been upgraded to 12 volt and a 35 amp alternator installed. I have all the 6 volt stuff in a box.
New wiring has been run but the lights still need to be hooked up.
Mostly original paint on truck and wood in the bed.
Few minor dents on the roof of the cab and the left side of the bed.
Good traction tires all around (even the spare matches!)
I have a set of 4.89 geared axles that I will install for a additional fee.
Price is $7000 OBO
I am located in Central Washington State.

Contact: Jonas Smith, 509-674-6840
I am going to post pictures on the photo classifieds this week.



Follow Ups:



Post a Followup

Name:
E-Mail:
Subject:
Message:
Optional Link
URL:
Title:
Optional Image Link
URL:


This board is powered by the Mr. Fong Device from Cyberarmy.com