Posted by mark on Friday, February 16, 2001 at 8:36PM :
In Reply to: 205 xfer case question posted by Chris on Friday, February 16, 2001 at 5:26PM :
are you sure you are in 4wd when lever is in 4hi? Could be a linkage problem. I had the same problem except that it was 4low. Had to keep my foot on the transfer case lever all the way forward to have 4wd low range. If I didn't I had low range but only 2wd. My rod to the trtansfer case from the lever was bent and my motor mounts were bad, every time the engine tranny moved it would come out of 4wd low range. When in 4 hi the 205 case should not act as differential, but just put power to front and rear axels. You have a nice truck. I have one just like it except w-200 with sweptside bed and no winch. Couldn't locate a utiline bed for it when doing my restore.
|
This board is powered by the Mr. Fong Device from Cyberarmy.com |