Posted by Vaughn on Friday, February 09, 2001 at 0:43AM :
In Reply to: Brake lines posted by Bill Cunningham on Thursday, February 08, 2001 at 12:10PM :
From pumpkin to wheel cylinders:
From "T" fitting on top of pumpkin, run your STEEL lines on the upper back side of the axle housing. You should have some clips bolted on the housing to hold them in place. Go down under the spring, behind the plate the "U" bolts go through up to the point where the brake hose bracket is. Hope this makes since.
|
This board is powered by the Mr. Fong Device from Cyberarmy.com |