Re: 20 inch wheel conversion plates

Posted by Daryl in Oz [210.50.228.6] on Wednesday, August 31, 2011 at 20:07:55 :

In Reply to: 20 inch wheel conversion plates posted by dan m [108.39.155.138] on Wednesday, August 31, 2011 at 19:44:12 :

Nice little '40 model. The wheel nuts front and back will fit the PW studs. I think the only ways to use these wheels would be to make a new center section and weld it in, or re-drill the PW hubs to this stud pattern.

Follow Ups:

• i am doing disc brakes and - dan m 22:19:41 08/31/2011
  • Re: i am doing disc brakes and - Daryl in Oz 03:53:27 09/01/2011
    • back to the drawing board: do you know a - dan m 07:29:52 09/01/2011
      • Re: back to the drawing board: do you know a - Daryl in Oz 18:22:38 09/01/2011
  • Re: i am doing disc brakes and - Ken Dunnington 23:19:28 08/31/2011
    • thanks ken - dan m 07:31:10 09/01/2011
  • Re: i am doing disc brakes and - clueless 22:31:35 08/31/2011
    • Re: i am doing disc brakes and - dan m 07:35:20 09/01/2011
      • Re: i am doing disc brakes and - clueless 09:40:19 09/01/2011

Post a Followup