|
|
Posted by Paul (in NY) [12.64.152.57] on Wednesday, April 13, 2011 at 23:10:56 :
In Reply to: Need some advice on PS conversion posted by Mike O in Colorado [97.118.25.81] on Wednesday, April 13, 2011 at 23:00:56 :
The lower bushing in Ray's kits is push in, friction fit. I drill/tap the bushing 2 places, 180 degrees apart. I then use a .250" long screw thru the outer column, into the bushing. Screw is retained with red lock tite.
On my trucks, I cut the outer column quite close to the engine side of the fire wall.
I fab a lower column retainer to secure the lower end of the column from moving. The inner shaft then goes to the U joint at the Saginaw Reverse Rotation PS Box.
Paul
Follow Ups: