For 4K you need to...


[Follow Ups] [Post Followup] [Dodge Power Wagon Forum]


Posted by rick pacholski [69.78.133.81] on Sunday, April 10, 2011 at 16:44:36 :

In Reply to: OT Flat Fender, Jeep posted by Ken See [68.9.139.131] on Sunday, April 10, 2011 at 11:43:37 :

run magnet all over the tub and tailgate. You should find "WILLYS" stamped on both sides of the hood and centered on the tail
gate. There should be one tail light ("NACO" or "Corcoran Brown" glass lens) on the left and one Corcoran Brown red glass reflector on the right. Check the ACM numbers on the body tag (pax side firewall next to VIN tag), the driver side body brace mounted to firewall, and the tailgate (pax side edge near bottom) The frame number (drivers side frame horn (outboard side). The Motor serial number is stamped on flat boss forward of the thermostat housing above water pump. You didn't show photo of motor so there should be an oil bath air filter on pax side firewall with metal crossover tube and maybe a couple of rubber tube connectors to air horn on Carter one barrel carb. Orignal electric is 6V positive ground with Autolite genny, voltage regulator, coil and distributor. Foot starter button. Check far left bottom of dashboard for the panel light switch. It's TINY! No back seat = $ off.



Follow Ups:



Post a Followup

Name:
E-Mail:
Subject:
Message:
Optional Link
URL:
Title:
Optional Image Link
URL:


This board is powered by the Mr. Fong Device from Cyberarmy.com