|
|
Posted by ChrisCase [63.199.247.20] on Monday, March 07, 2011 at 20:57:33 :
In Reply to: Re: Made from 3/4" diameter rod, two lengths posted by dave horvath [24.131.120.209] on Monday, March 07, 2011 at 19:26:30 :
I'll pick up enough mat'l do do a handful.
Manny, I'll need you to measure length, front bumper to dowel pin location. Use a dowel to make a mock up? Nail through it near the end? Small dowel will work. Or even a stick with that fit's through the...
No, wait. just use a straight piece of wire, brkke line, whatever. Measure front bumper to bottom of hole in end of crank.
Aww, wait a minute again. 3/4t frames are the same length as the PW, right?
Follow Ups: