Posted by Tim Holloway [69.54.28.229] on Monday, December 06, 2010 at 05:08:54 :
In Reply to: Fender update.. from hood latch rivet below posted by Nick [99.100.212.49] on Monday, December 06, 2010 at 00:13:06 :
Nick,
I put it on the floor on top of a couple of dowels (out at the edges)and stepped on it to put in a small arc. Then fine tuned with a hammer. When you weld it in, just spot it every inch, manipulating it in and out as needed, it will conform just fine. You are putting plates over both sides anyway. Done this with both Power Wagon and M37 fenders.
Tim
Follow Ups: