|
|
Posted by Terry [76.70.65.167] on Sunday, April 04, 2010 at 16:14:15 :
In Reply to: Re: oil leak revisit ? posted by bill in pa [75.196.4.191] on Sunday, April 04, 2010 at 15:13:30 :
Bill: check to see if the disc is flat when you remove it. Is the block scored in the seal area zone or should there be an oring installed instead of a paper gasket?. Is the inner hollow bolt assembly tight enough or does it bottom out before the disc is compressed into the gasket?. How thick was the paper you used.. 0.010", 0.015,0.020, or 0.032" . If you used one on the thin side try a thicker one.. just some thoughts .....Terry.