|
|
Posted by Doc Dave [69.19.14.26] on Wednesday, December 30, 2009 at 14:35:34 :
In Reply to: Engine Pre-lube posted by Andrew Moore [170.35.224.63] on Wednesday, December 30, 2009 at 12:20:40 :
What I did was simply disconnect the union in the oil pressure line (which is near the back of the block). I then installed a "t" brass fitting there that then allowed me to plumb in the rubber hose from the preluber into that. I needed to buy the t fitting as well as a male fitting for it that was "barbed" for the rubber hose to fit over. Inexpensive.
By doing this you can get oil throughout the engine before start up.