|
|
Posted by OleManIdaho [164.165.147.34] on Thursday, December 24, 2009 at 13:27:11 :
In Reply to: Heater tube question... posted by rick pacholski [98.26.211.168] on Thursday, December 24, 2009 at 12:44:30 :
I have used a round chisel before. Or any other round object that is just under the diameter of the tube. Copper is pretty soft so I just ream it around a bit until it is straightened out. I suppose there is some fancy tool to do it with but this works for me. Sometimes you might have to lightly hammer on the tube or tool kind of like doing bodywork.
Follow Ups: