Grind a big weld prep angle, clamp into angle iron


[Follow Ups] [Post Followup] [Dodge Power Wagon Forum]


Posted by Chriscase [76.201.19.122] on Wednesday, December 23, 2009 at 09:56:04 :

In Reply to: how to weld posted by Dave Royal [76.182.149.93] on Wednesday, December 23, 2009 at 03:01:53 :

Grind both pieces at a 45°, til they are only about 1/4" flat on the end. Then clamp into a piece of angle iron- clamp each piece both ways, need at least four clamps. Leave a 1/16" gap. After the first pass, weld beads should go lengthwise. Rotate 180 after each early pass, then maybe 90° ?

PITA, I'd make a new one if it doesn't have the six splined PTO end.



Follow Ups:



Post a Followup

Name:
E-Mail:
Subject:
Message:
Optional Link
URL:
Title:
Optional Image Link
URL:


This board is powered by the Mr. Fong Device from Cyberarmy.com