Re: Good Article on Flame Straightening

[Follow Ups] [Post Followup] [Dodge Power Wagon Forum]

Posted by David Beadle [136.168.107.144] on Friday, December 11, 2009 at 14:04:44 :

In Reply to: Re: Good Article on Flame Straightening posted by mannyc [68.165.89.2] on Friday, December 11, 2009 at 13:50:57 :

I have seen the same at some of the heavy fab shops. They take a piece of well casing, place a 12x1 inch structural bolt through the pipe and cast it in place when the slab is poured. Put a typical water valve cover on it to keep from falling ine. Invaluable addition to the shop with little $$.

Flame Bending and Straightening

Follow Ups:

My neighbor did that to his driveway. Plan was sailboat masts. - Chriscase 14:12:41 12/11/2009

Post a Followup

Name:
E-Mail:
Subject:
Message:

Optional Link
URL:
Title:
Optional Image Link
URL:

This board is powered by the Mr. Fong Device from Cyberarmy.com