|
|
Posted by Mikey Stone the COTM [71.39.211.43] on Wednesday, October 07, 2009 at 16:22:33 :
In Reply to: Old School - Grinding Rod Bearing in Engine posted by Paul Cook in Kempner, TX [72.173.160.58] on Wednesday, October 07, 2009 at 12:59:56 :
i brazed up a crack in my Fhead jeep engine
using eutetic 185 work hardening rod then
after peening the work used a valve seat
ream to make the new seat and finished it off
using a souix hard seat grinder (lucky i was
able to clean up the stone so it could be
re-used later.
today there are no fixers with the liability
problems.
car dealerships had engine rooms for repair
now it is just replace with a factory rebuild
old days old school