Posted by copey [206.80.248.239] on Sunday, August 30, 2009 at 19:33:56 :
In Reply to: Pinion Seal Question posted by Angelo [64.12.116.76] on Sunday, August 30, 2009 at 16:15:38 :
Having replaced many seals over a life time causes 1 improper seal instalation while pounding in place use a proper driver 2 the bearings thathold the shaft inplace are loose or worn 3 execessive pressure the vent is not open or clean to allow the pot to breath 4 over filled with oil apply a thin amount of oil on the seal so it doesnt have a dry start ~ copey