Re: Oil spitting out of the dipstick, SB 360 in a WM300

Posted by Curtis Burford on Sunday, August 16, 2009 at 22:13:51 :

In Reply to: Re: Oil spitting out of the dipstick, SB 360 in a WM300 posted by oldmopar on Sunday, August 16, 2009 at 22:03:26 :

I do have a mechanical oil pressure gauge but it comes out the back by the distributor and it's all dry back there. I think the fan is blowing the dropplets up there, and on the fender skirt too. I't wierd because not much else has oil on it. Not even the heater hoses that run through this area. The exhaust header bolt has drip on it and the pan is completely dry. The valve covers are cast allumium and seem tight over new rubber gaskets.

• The 360 in the frame

Follow Ups:

• Re: Oil spitting out of the dipstick, SB 360 in a WM300 - Milo/ in/ Pa 22:53:47 08/16/2009
  • New aluminum rockers need holes drilled for vent. - Chriscase 23:05:34 08/16/2009
    • You guys are good, keep thinking!!! - Curtis Burford 00:24:29 08/17/2009
      • PCV hose to correct fitting? - Chriscase 09:18:11 08/17/2009
        • Re: PCV hose to correct fitting? - Curtis Burford 20:09:40 08/17/2009
        • Re: PCV hose to correct fitting? - Milo/ in/ Pa 09:40:48 08/17/2009

Post a Followup