|
|
Posted by chuck vaughan on Thursday, August 06, 2009 at 08:25:26 :
In Reply to: Any good ideas for pressing a tapered shaft out? posted by David Sherman on Thursday, August 06, 2009 at 01:35:36 :
I had the same problem with my cj5 jeep axle but I finally got it. Sherman put the axle in ur 3 jaw puller or ur press and heat the hub good & hot and then wait about 20 minutes and give the heat time to soak in so to say. Then reheat it and see if it dont pop off. I had a good amount of pressure on my jeep and the dang thing popped off across the garage floor. I didnt think I had as much pressure as I did Woo wee !!