|
|
Posted by Daryl in Oz on Wednesday, July 01, 2009 at 18:58:33 :
In Reply to: is there anyone out there that might spare a moment and help posted by jim on Wednesday, July 01, 2009 at 17:37:47 :
You don't say how it's been modified, but if you are using the simple on/off ignition switch with foot or button starter, you usually have a live wire going from the battery or starter terminal to the ammeter, then from ammeter other post to ign switch. Next you need a live wire from the terminal that becomes live when the ign is switched on to go to the coil. If you have neg earth connect it to the + side of the coil, other way around for pos earth. Other side of coil has a wire going to distributor. If distributor is set up correctly this will work. You can run temporary wires to get you going until you trace out what you have, then connect the correct wires up and you are done. If you have a key start type ign switch it's a bit different.
Follow Ups: