|
|
Posted by Daryl in Oz on Monday, May 04, 2009 at 00:28:00 :
In Reply to: Just curious posted by David Sherman on Sunday, May 03, 2009 at 22:04:15 :
David, in the old days it was common practice with these and other engines where the big ends, mains and rings are easily done with engine in place, but the cam bearings usually only get done with a full overhaul. I've seen a lot of the "older" trucks get rings, bearings and valve grinds over the weekend then back to work monday. Eventually you have to do the cam bearings as well.