|
|
Posted by Philip Curry on Monday, February 23, 2009 at 09:41:02 :
In Reply to: Just a round pin. I used the butt end fo a drill bit. posted by Chriscase on Monday, February 23, 2009 at 09:18:27 :
Why is the chanel in the shifter wider than the hole that the pin goes into. I thought about putting in a pin that was tight to the hole but that would still allow a little side to side movement in the shifter. The old pin did get jammed between gears luckily I was only moving it into the garage to work on (other things that was).
Follow Ups: