Posted by copey on Wednesday, October 15, 2008 at 10:13:54 :
In Reply to: Rest of the information posted by Galen on Wednesday, October 15, 2008 at 09:06:40 :
ok fisrt open the distributor and put in a new set of points and condenser then set to specks on gap > now take a volt meter to wire to the points turn enine should have power when points close the no power when points open > next top up tank half or better prime carb with fuel care full here not to much gas,, should fire > if not check basic timing and distrubtor in relation to crank good luck
~ j