|
|
Posted by roger king on Tuesday, October 14, 2008 at 21:02:38 :
In Reply to: Tube Bender Recommendation/Suggestions posted by Will (in IL) on Monday, October 13, 2008 at 21:17:56 :
im using a protools 105 hd. with a cooper head fab cylinder adapter and a harbor freight air over hydraulic cylinder. i works real good. dont buy a notcher until you start bending tube. i have one but dont use it anymore. there is a great write up in pirate on using a chop saw which works great. also there is a write up called bending 101 that works real good. for weird angle notches i have found it quicker and easier to use a grinder on .120 and thinner. if you decide to go the protools way check out keith at offroad fabrication network.com. and by the way will. you are hooked just like me,you just dont want to admit it yet
Follow Ups: